PenMount 9000 Controller Chipset
(RoHS Compliance)
 PenMount 9000 is designed to have very good performance of RS-232 interface on the touch screen.
PenMount 9000 has been designed for those who may like an all-in-one solution with A/D converter built-in to make the total printed circuit board denser. Beside these individual controllers, For larger screen area compensation, it is sometimes necessary to use an 8 or 5-wire touch panel instead of 4-wire onces. The PenMount 9000 controllers in this case work properly for 4, 8 and 5-wire touch panel in a way that is totally transparent to the user.
PenMount 9000 Hardware Data
 PenMount 9000-458 Data Sheet
|
Touch Screen: |
4, 5 & 8 wire |
|
Package: |
32-pin TQFP |
|
Communications: |
RS-232 |
|
Baud Rate |
19200 and 9600 baud rate
selection, N81 |
|
Mode selection |
PnP or non-PnP mode |
|
Feature: |
8-bit RISC microprocessor with
built-in
functions including ADC, UART,
Timer, Counter, Comparator,
Watchdog, Memory, etc. |
|
Operating Voltage: |
DC +5V |
|
Power Consumption (Base on
PM9036BH board) |
Standby Mode : 16 mA ; Active
Mode : 27.5 mA
( VCC=+5V, Top sheet Panel
Resistance: 365 ohm ;
Bottom sheet Panel Resistance:
660 ohm )Note.
Actual current will be different
by touch panel’s resistance. |
|
Operating Temperature: |
-40o C to +85o C |
|
Storage Temperature: |
-65o C to +150o C |
Please refet to the data sheet describing ATmega8L-8AU from ATMEL for more detail.
PM9000 Controller Driver Software
DOS, Windows 3.1/ NT4.0/ 95/ 98/ Me/
2000/ XP/ 2003/ 2008/ Vista/ 7,
Linux (up to kernel 2.6), QNX 6.2/
6.3.2/ 6.4.1/ 6.5,
Windows CE 4.2/ 5.0/ 6.0 (for X86,
Armv4, Armv4i platform);
Solaris 10 |
